- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I"m very new to PSoC.
I want to let existing program which I got from another person to work.
The program have been built perfectly. So if I set my PSoC creator correctly, it can work.
However there is a note and a warning.
The note is "pft.M0040: The following 2 pins will be assigned a location by the filter:\USBFS_1:Dm(0)\,/USBFS_1:Dp(0)\"
The warning is "sta.M0021:Warning-1350: Asynchronous path(s) exist from "\ADC_DelSig_1:DEC\ /interrupt" to "CyBUS_CLK". See the timingreport for details.
When I try to program and debug, it collapsed by encountering error.
I'm afraid that the warning causes this error.
I know that ClockSyncronization is problem and I should add some clock components to my program.
Please teach me how to put clock component.
or should I have to change any settings?
I attached my time report also.
And I write configuration of my PC
Windows10
PCoS Creator 4.2
My board is PSoC 5lp (CY8C5)
Thanks in advance
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The error comes because of timing differences of clocking network. You can use a sync component to solve it.
Please check the following document : http://www.cypress.com/file/179056/download, page 20.
Best Regards,
VRS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you please post your complete project or a shortened version that shows the error so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm sorry...
After it took few minutes.
Above warning and note appear again...
I cannot solve the problem basically.
Misato
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The error comes because of timing differences of clocking network. You can use a sync component to solve it.
Please check the following document : http://www.cypress.com/file/179056/download, page 20.
Best Regards,
VRS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks!!
I could understand how to connect Sync components.
And I could solve the problem.
Regards
Misato