1 Reply Latest reply on Sep 30, 2018 10:38 PM by rroy

    WICED Studio 6.1.0: Breakpoints being forgotten between runs

    ed_3322321

      When I place breakpoints, they are not 'loaded' if I'm not running the firmware, i.e., there's no tick placed next to the breakpoint in the IDE.

       

      When I run the firmware and place a breakpoint, then it is properly loaded and the firmware will break as intended.

       

      This is annoying, because I have to reload breakpoints on every run!

       

      Is there a solution to this?