5 Replies Latest reply on Sep 14, 2018 1:55 AM by AnjanaM_61 Branched from an earlier discussion.

    Re: No access to CYBT-343026-EVAL board's Make Targets (con't)

      yssu

      Hello,

       

      As a follow on to this thread: No access to CYBT-343026-EVAL board's Make Targets

       

      I'm trying to test the CYBT-343026-EVAL card with Wiced, so I followed all the previous steps.

       

      When I build Make Target "demo.hello_sensor-CYBT_343026_EVAL download" Wiced can not detect my device ...

       

      Detection device ...

      ********* Detection fault *************

      + ------------------------------------------------- ----------------------------------------- +

      | The CYBT-343026-EVAL card was not detected. Verify that the device is connected |

      | power cycle if necessary to restart in programming mode, and try again. |

      | |

      | Refer to the Appendix sections of the Quick Start Guide to learn about common COM port problems.

      + ------------------------------------------------- ----------------------------------------- +

       

      So I tried to put my device in recovery mode (with SW2 switch switch), without success too.

       

      Do you have any idea why this is not working?

       

      Regarding,

       

      Thomas