Sep 05, 2018
03:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 05, 2018
03:12 AM
Hello,
The provision of the Internal Vref Startup Time of the component data sheet
Is it only the standby time at PowerOn? Or is it necessary to wait for every AD conversion?
MPN CY8C4145AXI-S423
Best Regards,
Naoaki Morimoto
Solved! Go to Solution.
1 Solution
Sep 05, 2018
11:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 05, 2018
11:19 PM
Hello Naoki san,
These startup times specified will be from the point where ADC_Start() is called. So this is a one time delay when ADC is being started. It is not needed to wait every conversion cycle for this much time.
Best Regards,
VRS
1 Reply
Sep 05, 2018
11:19 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 05, 2018
11:19 PM
Hello Naoki san,
These startup times specified will be from the point where ADC_Start() is called. So this is a one time delay when ADC is being started. It is not needed to wait every conversion cycle for this much time.
Best Regards,
VRS