S6J334EJE JUNO - Unused pins recommended configuration

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

We are developing a product, where the sleep current is critical.

How can we minimize the leakage current for the unused pins of the controller?

(As far as I know, a CMOS input can consume some uA, when floating, because of the internal CMOS structures. It will float somewhere "mid supply", and both pull up and pull-down transistors will conduct a little bit. An input with pull up or pull down should be theoretically better, than a complete floating input. However there is an input enable bit, so the input can be disabled, but I'm not sure about the effect, especially leakage current-wise.)

Thanks.

0 Likes
1 Solution
Nambi
Moderator
Moderator
Moderator
50 likes received 5 likes given 100 solutions authored

Hi,

Disabling the input through the input enable bit will help in minimizing the current consumption.

Regards,

Nambi.

View solution in original post

0 Likes
1 Reply
Nambi
Moderator
Moderator
Moderator
50 likes received 5 likes given 100 solutions authored

Hi,

Disabling the input through the input enable bit will help in minimizing the current consumption.

Regards,

Nambi.

0 Likes