3 Replies Latest reply on Aug 28, 2018 2:06 PM by JeHu_3414236

    Capsense tuner cannot detect activity

    JeHu_3414236

      I am using the CapSense Tuner I2C project but I cannot get any touch detection on my board.  The I2C connection is ok and it is reading 154pkts/s.  The graph in the tuner always reads no activity.  When I load my own application with SmartSense Full Auto Tune, I can detect slider and button press but the accuracy is bad.  If I try to enable Full Auto Tune in the Tuner project, it fails on connection and says checksum mismatch.  Does anyone know what I should change in the tuner project so I can see some activity?