I think you should check first for MiniProg3 revision#. It is indicated in the sticker on the MiniProg3 device.
The rev.*A device cannot support "power cycle" mode. After rev.*B, you can use power cycle mode.
It is Rev B but does not work. :-(
I see the power light goes on and off.
Removed the pull downs on both pins and still no work.
1 of 1 people found this helpful
Can you set it to 5-pin connector in the programmer settings and try?
Thank you Rajiv,
So why can I only use the 5 pin connector?
Is that stated somewhere in the documentation?
Is this just for the 8 pin device or for any of the 4013 parts.
Since I have to respin the board I might add the bigger parts
I did get to to work by soldering wire to the processor as the board was not laid out for the 5 pin connector.
Board respin time.
PSoC 4 supports only SWD programming/debugging; MiniProg3's both 10-pin and 5-pin connector provide signals for SWD. However, the 10-pin connector is primarily used for JTAG.
You can refer the following document to know which pins of 10-pin connector are for SWD-
I am very familiar with using the 10 pin for SWD. Done that on many other projects / products.
I will review the document.
Sent from my iPhone
O 778 735 0196
C 604 671 3153