2 Replies Latest reply on Jan 30, 2015 2:03 PM by MichaelF_56

    LED Configuration for 20736S

    PhGi_2174146

      The built in routines to control an LED (e.g. bleprofile_LEDBlink) all seem to work off the the LED being pulled high and the pin going LOW to turn the LED on.  Does anybody know if there Is a way to reverse this such that the LED on state can be HIGH?  I can't just swap the ON and OFF parameters because the end state is incorrect (HIGH instead of LOW).  I've tried changing the initialization state in the BLE_PROFILE_GPIO_CFG, but that doesn't seem to work.

       

      Thanks!