- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi akbar501 and arvinds,
Per this thread here: Creating .bin file for WsUartFu.exe
I have same problem in using WsUartFu.exe.
I tested same as akbar's comments below, but it did not work after downloading new f/w.
Moreover, I also tested it using *.ota.bin as arvinds's comments, but it also didn't work.
Did you resolve this problem? If then, could you let me know how did you do?
Test environments : SDK 2.1.1 and SDK 2.2.0, BCM20737TAG
1.) successfully flash board with uart_fimrware_upgrade hex
2.) convert hello_sensor hex to a bin using ihex2bin.exe (c:\ihex2bin.exe hello_sensor.hex hello_sensor.bin)
3.) run WsUartFu.exe (c:\WsUartFu.exe hello_sensor.bin COM1)
4.) get c:\WsUartFu: upgrade status Success
Thanks,
Sung-Mok
Solved! Go to Solution.
- Labels:
-
Peripherhal UART
-
SDK 2.X
-
Windows
- Tags:
- download puart
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I could not reproduce this, I was successfully able to upgrade the firmware using WsUartFu, I had an ota image with the following console
hello_sensor_create()
################# UPGRADE WORKS #####################
I tried the same on SDK 2.2.0, BCM20737TAG
Kindly verify the steps you are trying. Also post the errors that you are seeing.
thnx
vik86
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I could not reproduce this, I was successfully able to upgrade the firmware using WsUartFu, I had an ota image with the following console
hello_sensor_create()
################# UPGRADE WORKS #####################
I tried the same on SDK 2.2.0, BCM20737TAG
Kindly verify the steps you are trying. Also post the errors that you are seeing.
thnx
vik86