2 Replies Latest reply on Aug 23, 2018 10:41 AM by BushraH_91

    Is it necessary to send command 00h after reading status register(cmd: 70h) during a page read cycle(cmd: 00h 30h)?

      My device is S34ML01G2 SLC NAND flash. I am trying to check the busy status of the nand by sending 70h command and reading bit 6. The NAND however stays busy after issuing the address cycle. So, is it necessary to send 00h again after issuing 70h(as per datasheet it apply to random page read)?