- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I have been using PSoC Creator 4.2 to program several CY8CKit 059 boards. I jusr received some new (hopefully idential) boards. When I try to program it in the same way, the Select Debug Target dialog pops up but it shows the KitProg and a sub item called ARM Debug Port (which the previous units did not show). When I hit Port Acquire, it finds the ARM Debug port and reports that it cannot program it.
As far as I can see, the boards are the same (both REV006)
How can I program my new boards?
Dave
Solved! Go to Solution.
- Labels:
-
PSoC 5 Device Programming
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try to use the programmer to download your hex to the device.
Where do you get these kits?
Could you add your config figure in the programmer screen shot here.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try to use the programmer to download your hex to the device.
Where do you get these kits?
Could you add your config figure in the programmer screen shot here.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I bought both the previous set and the new set from DigiKey (same part numbers).
I used PSoC Creator to build and load the apps previously. Why can't I do it now?
I have installed PSoC Programmer. I don't know how to use it but I think I just made it work.
I now I seem to be able to build and download code from PSoC Creator.
What changed?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What do you change to make it work?
Use the programmer Utilities, you can update the kitProg. I only want you to have a try, maybe it can solve your problems.