Set the ECO captrim values for CYBLE-012011 Module as per below link.
Basically you need to add the below line in the event CYBLE_STACK_ON.
CY_SET_XTND_REG32((void CYFAR *)(CYREG_BLE_BLERD_BB_XO_CAPTRIM), 0xBCBC);
with above modification, I tested the project with no issues.
Gyan, thank you, I will be testing that this morning and will report back to you. I did find that in the community, but was unsure what to do, and there is a dialog in the clock tab of the DWR, but it was in direct capacitance, and the discussion in the forum talked about changing the values, but since there were appropriate looking values there, and I could not check them against the hex number shown, I was unsure what to do. I will check to see if adding this line changes the displayed values in the DWR dialog.
Thanks again, Herb
Gyan, thank you again, BLE is now working fine!!!!
A suggestion, improve the posting and message with values you can input here, instead of just the hex values in the instruction, these values did not change with the code, so a big chance for an issue.
Thanks again, I really appreciate your support.