- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Would love to have these two nand flashes connected back to back on our PCB, so that we can optimize the layout.
Thanks,
AQ
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
We have a footprint for the 48 pin TSOP1 package. I am attaching the document with the details. We do not have a mirror footprint for two devices. You may need to take reference from the file below.
Thanks,
Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Pradipta for the reply.
What you sent were the details on the dimension of the package.
When you said "We do not have a mirror footprint for two devices" did you mean that a mirror footprint is not available for S34ML16G202TFI?
Thanks,
AQ
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Are you looking for a reference schematic in Cadence ? Can you clarify your requirement.
Thanks,
Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I asked for clarification on your comment.
Never mind.
Thanks,
AQ