1 2 Previous Next 16 Replies Latest reply on Jul 26, 2018 2:40 AM by veb_3529051 Branched to a new discussion.

    Failed to execute of HCI Commands

    veb_3529051

      Hi,

       

      I was trying to execute the HCI Commands, when i sends commands i'm getting the error as shown below

      once i give manual reset its working fine, that is also only one time, after that no response back as show below

      And when i'm trying to execute the LE Receiver Test, getting the below response

       

      kindly help to identify the mistake i was doing.

      Thanks

        1 2 Previous Next