2 of 2 people found this helpful
Firstly, please select "Dual core" option to allocate the BLE stack to both cores to eliminate the building error.
Then you can add "\r\n" in each printf() function, as below:
thank you for the fast reply.
Could you tell me where the failure was?
Was it the missing \r\n or the BLE Stack?
Would be good to know to avoid similar failures.
1 of 1 people found this helpful
Your project is not building because in top design you have selected Single Core (CM4) but you were trying to initialize the BLE controller from CM0+.
In case of 'printf', if you want to output the string then '\n' is needed to output the data.