Can you please provide more clarity how are you using PSoC5LP's USB port pins for programming.Are you referring to HSSP mode or something else.
You are referring to this KBA:
If you check the datasheet page#07-08 of PSoC5LP at this link:
It is mentioned that P15.6 & P15.7 can act as USB_Dp/SWDIO and USB_Dm/SWDCLK.
But, if you check datasheet page#14 of PSoC6 at this link mentioning about Alternate Function possible for each pin, There is no alternate function mentioned for P14.0 & P14.1:
I can find that P14.0 and P14.1 can act as only USB_Dm and USB_Dp only as mentioned on page#20.
So, I think that this feature is not possible for PSoC6.
Hi Anks. I am referring to the docs mentioned. I also gathered that the PSoC6 did not support it, but needed to confirm before I change my designs to another connector.
It was very handy as I placed a 5-pin USB connector on the board with pin 4 wired to reset. I used my normal programmer to program the bootloader through the SWD facility and then used USB to upload the application and do field upgrades.
I will now have to change this strategy.