8 Replies Latest reply on Jul 31, 2018 2:28 AM by info_3252411

    add usb host on  CYW943907AEVAL1F

    chengyake2008_3514166

      I’m trying to add usb host on CYW943907AEVAL1F reference CYW943907AEVAL1F USB Host Application Explained .But I have not distribution IC. so:

      Pull WICED_USB_HOST_POWER_ENABLE pin low through a 10k resistor (based on the pin defined in platform.h)

      Pull WICED_USB_HOST_OVERCURRENT pin high through a 4.7k resistor (based on the pin defined in platform.h)

       

      Log:

      +-------------------------------------------------+

      + USB20 Host HID Mouse Class Application          +

      +-------------------------------------------------+

      > USB20 Host init starting...

      Detected board strapping is in USB-PHY mode!!

      Detected board is in USB Host mode!!

      USB Host support 2 HCI resource

      USB20 Host init completed!!!

      hid_mouse

      +++START: hid mouse test

      Please plug in USB mouse...

      Please plug in USB mouse...

      Please plug in USB mouse...

      Please plug in USB mouse...

      Please plug in USB mouse...

      (plug in usb mouse...and... the board reboot...

      +-------------------------------------------------+

      + USB20 Host HID Mouse Class Application          +

      +-------------------------------------------------+

      > USB20 Host init starting...

      Detected board strapping is in USB-PHY mode!!

      Detected board is in USB Host mode!!

      USB Host support 2 HCI resource

      USB20 Host init completed!!!

       

       

       

      Does anyone have any suggestions?