- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I trying to implement bootloader in my project using the UART component. In did a few projects with RS232 and i2c and all worked OK, I guess it's not working because RS485 is half duplex . i didn't find any code example for that kind of bootloader...
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes you are right. Since RS485 is a half duplex communication, you need to configure your UART component correspondingly. There are no official code examples from Cypress, but you can find your solution here on the thread below:
Re: Implementation of RS485 on PSOC4
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes you are right. Since RS485 is a half duplex communication, you need to configure your UART component correspondingly. There are no official code examples from Cypress, but you can find your solution here on the thread below:
Re: Implementation of RS485 on PSOC4
Regards,
Dheeraj