I change LED blink period by using OTA external memory, I perform it with CYBLE-212006 module on custom PCB.
After hardware upgrade is completed through CySmart, the device isn't reset automactically and both LED and Bootlading_LED turn off.
I run in debug mode and verify Bootloader Host sent the "BootloaderEmulator_COMMAND_EXIT" command.
The code I use is below,F-RAM on custom PCB is MB85RC1MT and I2C address is same as the example.
VIO1 is connecting to F-RAM's VDD, I turn on VIO1 after enable the bootloader service.
Please help me to solve this problem.
I solve the problem.F-RAM's power is controlled by VIO1,but I didn't turn on VIO1 in project bootloader.
So after bootloadable receives the new image and writes the image into F-RAM,the firmware passes to the bootloader.
Because VIO1 doesn't turn on, the bootloader can't read the image from F-RAM.