- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have cy8ckit-049-042xx. I want to use it to program another cy8c4245axi-483.
So, according to datasheet, I have removed the r6 resistor and placed the jumper.
Also, by using 5 jumpers, I have connected the programming pins to another circuit (which is a touch panel having cy8c4245axi-483 IC), so as to program that IC.
But instead, I end up programming the IC on the board itself rather than that on the touch panel.
I have attached the picture of the circuit arrangement.
Need your help.
Thanks.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Although I have not tested this by myself, this URL could be a hint/help.
Using the CY8CKIT-049 to Program Another PSoC® 4 - KBA93541
moto
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The J2 PROG interface are reserved to use the minprog3 or other device to program the kit-049 CY8C42454245AXI-483.
The details you need to read the Kit user guide page 19.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you but I couldn't find in the user guide what you suggested.
I am using cy8ckit-049-42xx.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Although I have not tested this by myself, this URL could be a hint/help.
Using the CY8CKIT-049 to Program Another PSoC® 4 - KBA93541
moto