6 Replies Latest reply on Jun 5, 2018 12:59 AM by fwan

    PSoC 6 PWM+IRQ not working

    bneduva_3294706

      I have a project where I am trying to use an interrupt-triggered PWM which controls the configuration of the onboard LED and output the results. I have attached my project as a .zip and was hoping for some advice as to what I am doing incorrectly? The main files to look at here are main_cm0p.c and LightControl.c (I don't suspect that the header files are the source of my issues)

       

      I have consulted others with some PSoC 6 experience, and the feedback I received was that this code should work fine. My issue is that after running the code, the LED does not even flash at all.


      Am I missing something here? Any and all advice would be greatly appreciated!