Hi, I was able to program the 062kit using these parameters (with power cycle instead of reset).
It works at 1.8V and 2.5V, but not at 3.3V. Will the PSoC 6 run at 3.3V, or does it require a lower voltage?
There is a over voltage protection circuit on the kit board. This is to ensure that PSoC 6 MCU and other 3.3 V devices do not get damaged due to overvoltage. The voltage from the mini-prog 3 may be a little higher than the protection voltage and the chip is powered off.
You can find it in the A.3.1 chapter.
Ok, thank you.