8 Replies Latest reply on May 31, 2018 10:44 AM by JoGr_3357391

    phantom parts in topdesign


      Using a CYBLE-214015-01 using PSoC Creator  4.2 ( I had removed a component, yet when I try to build the project, I get errors indicating that the part I removed is not properly connected to any nets. The part shows up nowhere except in the error messages, but clearly some bit of configuration still believes it's there.


      I created a duplicate project and copied in the parts of the old design that are still there, and it builds OK. This doesn't sound like an efficient strategy moving forward, so how can I do a more complete cleanup of the project to make sure these phantom parts don't drive me even battier than I already am?