3 Replies Latest reply on May 24, 2018 8:20 PM by wxh0000mm_2441571

    CYUSB3035can't boot correctly

    wxh0000mm_2441571

      I use the CYUSB3035 chip to set the boot option to 100 (S0 port (eMMC)), which cannot boot the eMMC.When set to 000,  can normally burn the firmware and prompt for success.I set the pin of the three boot options to GPIO input, and the corresponding input voltage is set to 100, which can read the input voltage normally and read the correct input voltage 100.Is there any way to know why can't boot correctly?