2 Replies Latest reply on May 22, 2018 12:26 PM by user_301665782

    AN 66477 Multi Thermistor connected in parallel

    user_301665782

      Hi There

       

      I am intending to implement a 5 thermistor meassuremet system and current measuremet system in the same project but no dependent from the thermistor one.

      For thermistor I done the schematic based on AN 66477.

      The code for the 5 thermistor  compile well and I able to do measurements with those 5 thermistor.

      Whent I add  some more components for current measuremnt the code does not compile  indicating that Psoc Creator can't fin routing solution

      So my question is how can I set the 15 thermistor pins only over AMUXBUS so that leave free the AnaloGlobals for routing the other component.

       

      I watched the Mark Hastings' four videos about analog editor and he said that is posible to connect  almost all pins to AMUXBUS.

      I look for asnwer here an other Psoc forum but ther is no similar question or concret answer.

      Please see attached project.

      Thanks for some help.