Update it with Ez-PD configuration Utility.
CMG1 EVK is not scheduled.
The Ez-PD configuration Utility showed the error,"Failed to communicate with CCGx device over I2C",
when i connected the host board of the CCG1 evk.
In the previous post, you said it is caused by the some issues in the Ez-PD configuration Utility.
When will this issues be fix, any schedules?
Are there any method i can update the table without using the CCG1 host / client board to configured the table?
Or can you recommend the other evk which updates the configure table of the ccg2 through the cc pin.
The schedule of Ez-PD configuration Utility is unclear. The way I can recommend you is you could use CY4532 for CCG2 cable or CMG1 cable programming.
Thank you for your understanding.