2 Replies Latest reply on Mar 13, 2015 2:54 PM by seyhan

    Broken Soft AP interface in SDK 3.1.1 at powerup

    feng@ibiquity.com

      Hi,

       

      We use WICED SDK 3.1.1 and the Inventek module  ISM43362_M3G_L44 which uses the STM32F205 processor.

      below is our code. We try to create two sockets on the AP interface

       

      void application_start( )

      {

       

       

      ........

             /* Bring up the soft AP network interface */

            if (wiced_network_up( WICED_AP_INTERFACE, WICED_USE_INTERNAL_DHCP_SERVER, &device_init_ip_settings)!=           WICED_SUCCESS)

             {

                  WPRINT_APP_INFO(("Bring up the soft AP network interface failed\r\n")); //never get here

             }

       

       

       

       

        /* Create a TCP server1 socket  */

             if (wiced_tcp_create_socket(&tcp_server1_handle.socket, WICED_AP_INTERFACE) != WICED_SUCCESS)

             {

                 WPRINT_APP_INFO(("TCP command socket creation failed\r\n"));//never get here

             }

       

       

       

       

               /* Create a TCP server2 socket  */

              if (wiced_tcp_create_socket(&tcp_server_handle.socket, WICED_AP_INTERFACE) != WICED_SUCCESS)

              {

                  WPRINT_APP_INFO(("TCP socket creation failed\r\n"));//never get here

              }

       

        /* wifi netwok interface is broken here at power-up, but not jtag loading*/

       

        while(1)

      }

       

       

      we use an android tablet and it can always connect to the wifi ap interface  after jtag loading image, but it cann't connect to the the wifi ap interface(" the  wifi ap interface not in range") when powering cycle the board after  jtag downloading was done..

       

       

      We can't see this issue in SDK 2.4.1.

       

       

      Can you investigate this?

       

      Thanks