- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
i am new with Broadcom, and i have some questions about UART.
How configure UART ( key steps ) to P32,P33 for basic communication ( write something on Tx and catch response Rx pin ). What is best way? I tried sample from docs, but without success.
How to configure UART for using ble_trace ( to read messages from Tx pin )? What are key steps? Is it possible to use both at the sametime?
Solved! Go to Solution.
- Labels:
-
Debug
-
Peripherhal UART
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This link has a sample app called APP_PUART, kindly try the same if you run into issues let us know. This answers both your questions
Re: How can I reassign port pins to GPIO after they have been assigned to puart_tx and puart_rx?
thnx
vik86
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This link has a sample app called APP_PUART, kindly try the same if you run into issues let us know. This answers both your questions
Re: How can I reassign port pins to GPIO after they have been assigned to puart_tx and puart_rx?
thnx
vik86
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you.