1 Reply Latest reply on Mar 4, 2018 4:58 PM by YuxianL_01

    Programming Error

      I have a CYC8KIT-059 board, and I'm using PSoC creator 4.2. After a while I started getting an error that the firmware was out of date. I finally figured out how to update it using PSoC programmer, but now when I go back to Creator and try to program the device I get the following error:


      There was an error while programming the device: PSoC Programmer reported error (100 - FAILED! EraseAll operation failed!

      Unknown error)


      I am at a loss here. Any help is greatly appreciated.