About driver connect with cy7c68013a

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

I made a board based with ug-293 and hsc-adc-evalcz from analog device.

When I connect to the board, the usb port does not recognize the usb board.

So I have several questions about this.

1. When I buy a new chip, do I have code this? Or it is coded?

1-1. If It is coded, how do I have to connect with PC? I connect the USB2.0 with D+, D- but there's none of the recognition of PC and new board.

1-2. If It is not coded, which pin do I have to connect to code?

0 Likes
1 Solution
Anonymous
Not applicable

Hi,

By default, the  bootloader code runs on a new chip. So the device should show up in the device manager. If not, this could be a hardware issue. Please make sure the USB connections are fine.

Regards,

- Madhu Sudhan

View solution in original post

0 Likes
1 Reply
Anonymous
Not applicable

Hi,

By default, the  bootloader code runs on a new chip. So the device should show up in the device manager. If not, this could be a hardware issue. Please make sure the USB connections are fine.

Regards,

- Madhu Sudhan

0 Likes