- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi all
i am new embedding.
i am developing BLE beacons. Once my software s ready on development KiT
how will transfer software into BLE chips for final products.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When you create your own hardware, include the standard 10-pin or 5-pin debug connector or test points so you can connect to the SWD pins, reset, VDDD and VSSS. The SWD pins are documented in the device datasheet as SWDIO and SWDCLK which are ports P0.6 and P0.7. Then use a Cypress MiniProg3 to program and debug your hardware. If you wanted to go on the cheap, you could use your Pioneer kit as the programmer as well. Remove the BLE module from the socket and use the 5 pins on the lower left of the module connector to connect to your hardware. You can see the pins labelled SWDIO, SWDCLK, RST, GND, and VDD. Just think of your hardware as the BLE module in the CY8CKIT-042-BLE Pioneer kit.
Mark
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When you create your own hardware, include the standard 10-pin or 5-pin debug connector or test points so you can connect to the SWD pins, reset, VDDD and VSSS. The SWD pins are documented in the device datasheet as SWDIO and SWDCLK which are ports P0.6 and P0.7. Then use a Cypress MiniProg3 to program and debug your hardware. If you wanted to go on the cheap, you could use your Pioneer kit as the programmer as well. Remove the BLE module from the socket and use the 5 pins on the lower left of the module connector to connect to your hardware. You can see the pins labelled SWDIO, SWDCLK, RST, GND, and VDD. Just think of your hardware as the BLE module in the CY8CKIT-042-BLE Pioneer kit.
Mark
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank You Mark !!!
Let me try this
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi
1) Can I use PSoC® 6 BLE Pioneer Kit
2) Only 5 Pins required SWDIO, SWDCLK , RST, GND, and VDD?
Any Document on this ?