Anonymous
Not applicable
Feb 21, 2018
12:17 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 21, 2018
12:17 AM
I bought a development board for 100 connections.
I turned off serial flash to work in standard Bluetooth HCI mode.
=> off 1-5 in SW7
I make a USB connection to raspberry pi and connect the device with the hciattach command.
=> hciattach /dev/ttyUSB0 any 3000000
=> hciattach hci1 up
However, a timeout occurs.
what's wrong?
Solved! Go to Solution.
1 Solution
Feb 28, 2018
01:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 28, 2018
01:58 AM
A manual board reset or recovery procedure may be needed to restore the board to Bluetooth HCI mode.
And try baud rate = 115200
The documents "WICED HCI UART Control Protocol" locate in wiced/Doc should be helpful.
Regards
Jenson
1 Reply
Feb 28, 2018
01:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 28, 2018
01:58 AM
A manual board reset or recovery procedure may be needed to restore the board to Bluetooth HCI mode.
And try baud rate = 115200
The documents "WICED HCI UART Control Protocol" locate in wiced/Doc should be helpful.
Regards
Jenson