1 Reply Latest reply on Feb 18, 2018 10:31 PM by ManaskantD_51


      How ez-usb-fx2lp automatically loads c2 load eeprom boot(24LC128-16KB-2 bytes address)?

      which eeprom will select if i connect two eeprom with same size to fx2lp on I2C bus?

        • 1. Re: FX2LP EEPROM

          The EEPROM selection is based on its Slave address. Both the EEPROMs should not have the same I2C slave address. Please refer to the FX2LP Technical Reference Manual or the datasheet to determine the correct slave address to boot from I2C EEPROM.

          1 of 1 people found this helpful