- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In PSoC 4 L there are pins that can not be HW Connection with the Digital Output, Input of Pin component.
(Error at Build)
I think that it will be an error because I can not connect DSI (Digital Signal Interconnect) to this Port.
Is there a way to determine which Port this kind of DSI can not be connected to?
Takahashi
Solved! Go to Solution.
- Labels:
-
PSoC 4 Architecture
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Kenji san,
This informaiton is available on the using GPIO appnote <http://www.cypress.com/file/127101/download
So P4 and higher ports will not have DSI connectivity.
Best Regards,
VSRS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is not an error, it is device dependent which ports are not connected to the DSI. Check for your PSoC4 datasheet.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Kenji san,
This informaiton is available on the using GPIO appnote <http://www.cypress.com/file/127101/download
So P4 and higher ports will not have DSI connectivity.
Best Regards,
VSRS