Anonymous
Not applicable
Feb 01, 2018
01:52 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 01, 2018
01:52 PM
Working with the PWM component V3.30 in PSoC Creator 4.1 on a PSoC3. It reports to the output window that the build was successful. However in the notice list there are 2 errors. Both are sdbM.0050. One is: Terminal "capture" requires connection when it is visible. The other is: Terminal "trigger" requires connection when it is visible. I have both pins invisible. With the Trigger and Capture function set to 'None' on the Advanced Tab in the configuration dialog. I'd rather not have to make them visible and orchestrate logic to make the part run in just continuous mode. Is there something I've missed?
Solved! Go to Solution.
Labels
1 Solution
Feb 04, 2018
09:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 04, 2018
09:55 PM
1 Reply
Feb 04, 2018
09:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 04, 2018
09:55 PM
Please close and reopen the creator, Notice list will be cleared