7 Replies Latest reply on May 26, 2015 4:41 AM by georgschmidt

    Uploading Code via Olimex ARM-USB-TINY-H doesn't work

    georgschmidt

      Hi there,

       

      I'm trying to use a Olimex ARM-USB-TINY-H with SN8200 module to upload the demo appliance from WICED SDK 2.4.1.

      I'm using the following task:

      demo.appliance-SN8200x JTAG=Olimex_ARM-USB-TINY-H download run

       

      Now I'm getting the following console output:

      -----------------------------------------------------------------------------------------------------------------------------------------------

      Build complete

      Downloading Bootloader ...

      Download complete

       

      Downloading Application ...

      "**** OpenOCD failed - ensure you have installed the driver from the drivers directory, and that the debugger is not running **** In Linux this may be due to USB access permissions. In a virtual machine it may be due to USB passthrough settings. Check in the task list that another OpenOCD process is not running. Check that you have the correct target and JTAG device plugged in. ****"

      Downloading DCT ...

      Download complete

       

      Resetting target

      Target running

      -----------------------------------------------------------------------------------------------------------------------------------------------

       

      So it seems that the bootloader and the DCT will be downloaded to the module, but not the Application.

      Can anybody tell me what's going wrong here?

       

      Regards,

      Georg