- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I want to use a CYW20706 soc for a embedded Bluetooth application and could not find information how to flash my compiled program to the chips memory.
Do i need a extra programmer device, like for atmels atmega, or just USB to uart transmitter and the program is transmitted via the uart interface ?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Je,
The CYW20706 is programmed over the HCI UART interface.
For steps involved in the programming of CYW20706, kindly refer to the "Downloading the Application ...." section in the 'WICED-HCI-Control-Protocol' document included in WICED.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Je,
The CYW20706 is programmed over the HCI UART interface.
For steps involved in the programming of CYW20706, kindly refer to the "Downloading the Application ...." section in the 'WICED-HCI-Control-Protocol' document included in WICED.