- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!
I want to program CY8CMBR3110 with the Arduino IDE or similar.
The 128-position EZclick-generated programming matrix: Ex: ... .0x78u, 0x00u, 0x00u, 0x00u, 0x00u, 0x00u, 0x00u, 0x00u, 0x00u, 0x00u, 0x00u, 0x00u, 0x7u, 0x7Fu, 0x7Fu, 0x7Fu, 0x80u, 0x80u .... I want to know who the recorder is for each array position above, since I want to program for low power consumption like look-for-proximity
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!
Please refer to the MBR3 CapSense Design Guide (Section 5.2) at the following link:
http://www.cypress.com/file/127221/download
You can configure the MBR3 using host APIs.
The 128 bytes .iic files generated from Ez-click can be used.
The 128 bytes of configuration data are defined in the registers TRM at the following link:
http://www.cypress.com/file/127221/download
Thanks,
Shanmathi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!
Please refer to the MBR3 CapSense Design Guide (Section 5.2) at the following link:
http://www.cypress.com/file/127221/download
You can configure the MBR3 using host APIs.
The 128 bytes .iic files generated from Ez-click can be used.
The 128 bytes of configuration data are defined in the registers TRM at the following link:
http://www.cypress.com/file/127221/download
Thanks,
Shanmathi