3 Replies Latest reply on Dec 5, 2017 8:00 AM by urchc_1533771

    Pioneer Kit not communicate to PC


      My Pioneer Kit not communicate to PC ( No one port in Teraterm). Status LED blinks slow.

      In Guide I see that need " bootload the new .cyacd file using the Bootloader Host tool shipped with PSoC Creator."

      I run Bootloader Host tool but it can't communicate by USB because this problem.

      So I connected to Kit  with MiniProg3 by 5 pin connector (J7) .

      I can comunicate to device by this MiniProg3 for write firmware (see attached PK1.png) but Bootloader Host tool can`t ( see attached PK2.png)

      Other same Kit is working well so it`s only this Kit problem.

      How can I solve this problem ?