- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hii
i am using FM4-S6E2CC-eth kit i am trying to understand the pin connection of SRAM to controller but it look to be different and confusing so please help me or let me know how pin configuration has been done
HERE what is UB and LB where pin no 21 and 22 are configure as i see no pin in the datasheet of CY62147EV30LL-45B2XI SRAM
thank you in advance
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Sourabh,
/UB and /LB lines (Pin 22 and 21) of SRAM in S6E2CC schematic are Byte High Enable (/BHE) and Byte Low Enable (/BLE).
Regards,
Geona Mary
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Sourabh,
/UB and /LB lines (Pin 22 and 21) of SRAM in S6E2CC schematic are Byte High Enable (/BHE) and Byte Low Enable (/BLE).
Regards,
Geona Mary
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank u so much Geona for your precious time and reply