Attachments are accessible only for community members.
Dec 02, 2017
08:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 02, 2017
08:27 AM
In AN86233_PSoC_4_Low-Power_Modes_and_Power_Reduction_Techniques(2)_0.pdf I saw recommendation to reduce power by change debug pins to GPIO mode. See attached pic. After I done it I can`t acces to my device !
Programmer can`t acquire SWD
What to do ?
Solved! Go to Solution.
Labels
- Labels:
-
PSoC 3
1 Solution
Dec 03, 2017
05:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 03, 2017
05:20 AM
This is duplicate of thread Can`t program my device after Disable Debug Interface to Reduce Power
Check out Re: Can`t program my device after Disable Debug Interface to Reduce Power for solution.
1 Reply
Dec 03, 2017
05:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 03, 2017
05:20 AM
This is duplicate of thread Can`t program my device after Disable Debug Interface to Reduce Power
Check out Re: Can`t program my device after Disable Debug Interface to Reduce Power for solution.