Can`t program my device after Disable Debug Interface to Reduce Power

[urchc_1533771]

In AN86233_PSoC_4_Low-Power_Modes_and_Power_Reduction_Techniques(2)_0.pdf I saw recommendation to reduce power by change debug pins to GPIO mode. See attached pic. After I done it I can`t acces to my device !

Programmer can`t acquire SWD

What to do ?

[SrikanthD_56 · Accepted solution]

This is duplicate of thread Can`t program my device after Disable Debug Interface to Reduce Power

Check out Re: Can`t program my device after Disable Debug Interface to Reduce Power for solution.