1 Reply Latest reply on Dec 3, 2017 10:12 PM by mddd

    FX3 USB BulkLoop-Auto Example - Device fail to enumerates as a vendor specific USB device in control center

    maheswariamudha_2545856

       

      when I connect device with PC through usb3.0 and download USBBulkLoopAuto to the FX3. USB control center does not displays the device . I tried to force bind but it fails.I have attached the screenshot.How to solve this issue.

       

      I have made modifications to USBBulkLoopAuto project .In the firmware I am monitoring the GPIO and whenever negative edge appears on this GPIO I am sending 2 bytes to the Host (which are 0x0A and 0x0B) over the interrupt endpoint.

       

      bulkloop.PNG