5 Replies Latest reply on Dec 4, 2017 6:43 PM by xht

    How to change the clock output of the CY29412 without using the Clock Wizard

    shimamura-s_1535366

      Hello,

       

      I would like to change the clock output via I2C for clock evaluation.
      However, only changing the I2C register (10h to 15h) did not change the clock output.
      I could read that "Large Change" or "Small Change" command was needed from the datasheet, but I could not find information about those commands.

      How do I change the clock output from the I2C master without using the Clock Wizard?

      In what sequence should I access I2C slave?

       

      Regards,

      Shimamura