Attachments are accessible only for community members.
Anonymous
Not applicable
Nov 13, 2017
01:38 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 13, 2017
01:38 PM
I'm trying to create a bulk data channel between the FX3 and host. The data input to the FX3 is fed by an FPGA. I have pretty much used the slavefifo application(AN65974) as the reference but modified the following : 1)The data channel between the FPGA and FX3 is 16 bits wide.
As usual,windows recognizes the FX3 as a bootloader device and so does the control center. However, after programming, I do not see the device anywhere. The enclosed document has screenshots of the problem.
Thanks in advance.
HV
3 Replies
Anonymous
Not applicable
Nov 14, 2017
07:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 14, 2017
07:44 AM
Hari,
Please attach your firmware after modification.
Regards,
- Madhu Sudhan
Attachments are accessible only for community members.
Nov 14, 2017
09:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 14, 2017
09:00 AM
Nov 16, 2017
09:04 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 16, 2017
09:04 AM
I’m wondering if anyone else has a similar issue with devices not enumerating after programming them.
Thanks,
Hari