- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I would like to use a proximity detector, the application I'm looking for is:
When I put my finger close to a sensor , the sensor detect it.
the issue is that I need: while I keep my finger close to the sensor (1-6 minutes), the sensor still detect that and not calibrate itself and toggle the output.
The interface must be GPO and not I2C...!
Does CY8CMBR3102-SX1I apply my need?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You may consider to use PSoC4 device, with which you can customize your application(prox detection reaction behaviors) flexibly.
MBR3 device is not that flexible.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You may consider to use PSoC4 device, with which you can customize your application(prox detection reaction behaviors) flexibly.
MBR3 device is not that flexible.