- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello! I did personal board with FX3 CYUSB3014. Connection with computer is via cable USB2.0. But chip CYUSB3014 is not shown in hardware monitor.
I think thhat problem can be in different voltages in VIOx. I use:
========
VIO1=3.3
VIO2=3.3
VIO3=3.3
VIO4=3.3
========
VIO5=1.8
Is it correct? Or all VIOx must be the same: VIO1=VIO2=VIO3=VIO4=VIO5?
What can I view in addition?
Thanks for any answer!
REgards, Evgeniy
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Evgeniy,
VIO5 can operate at different voltage level than VIO1-4.
The enumeration issue can be because of a large mismatch in the trace lengths of USB lines.
You can refer to the FX3 Hardware design guidelines AppNote to make sure that the board design is correct:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Evgeniy,
VIO5 can operate at different voltage level than VIO1-4.
The enumeration issue can be because of a large mismatch in the trace lengths of USB lines.
You can refer to the FX3 Hardware design guidelines AppNote to make sure that the board design is correct: