1 Reply Latest reply on Sep 20, 2017 8:43 AM by user_1377889

    power on rest

    m.trotta_1730276

      Hello,

       

      I've a question.

      In PSoC5 if I set in the pin configuration -> Reset -> Power-On Reset -> Pulled Up, does it means that the pin is pulled up if a reset occurs (for example for a watchdog or if I force a sw reset ....) or it is pulled up Always in every condition also at Power On ?

      Thanks and regards

        • 1. Re: power on rest
          user_1377889

          The pins are originally in Hi-z mode when the chip is powered. This lasts until the configuration of the pins is loaded into the registers as part of the boot process. For a PSoC5 you can specify a different mode for this time span when required. When the boot process is finished the pin configuration is always what you specified for the pin component.

           

          Bob