- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I use the PSOLC 4 CY8C4247LQI-BL483, and I want to communicate the psoc with the SD card to create a file and after storing the data, the card works in SPI, I use a program I found on this site but it works not !! you can help me solve this problem if you please. thank you
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Did you format the card correctly? Some FileSystem libraries need the card to be formatted. Also can you please try to use SD cards of different sizes and check any of them are working.
Thanks,
Hima
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thank you hima for your responce, yes I formatted the SD card well before use and I use a 32GB SD card.
Mbarek
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Can you use smaller size SD Cards like 2GM and all. If that is also not working, can you please probe the lines and check if any signal is coming on the lines at all?
Thanks,
Hima
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone,
I work on the CY8C4247LQI-BL483, i've try to test all your example and no one works. I've always a pin guidance error or 'SPI_SS_Write" error. So please, does anybody have a proper project that can match with my chip ?
Or try to help me with a list of things to do ?
Thanks,
Vivien
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Easiest to help you is always when you upload your current project. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I get a bunch of warnings and two errors when I build your project with Creator 4.1.
Also, some of the components could be updated to newer versions.
I never had issues with the pin guidance. Best suggestion is: after a successful build try to lock the pins in the pin view.
Bob