2 Replies Latest reply on Sep 18, 2017 5:06 AM by decai.wang_2529456

    CX3: usb control center , download inage into spi flash,but programming failed

    decai.wang_2529456

      Dear sir,

       

      When I download image to SPI flash (not Micron M25P40,I use ST 25P40 instead of micron M25P40, both of them are compatible and  operation code are same) by USB control center, programming failed, uart info is :

       

        <   0: Device initialized. Firmware ID: 50 33 58 46 0 47 4F 52

        <   1: Device initialized. Firmware ID: 50 33 58 46 0 47 4F 52

        <   2: Device initialized. Firmware ID: 50 33 58 46 0 47 4F 52

        <   3: Device initialized. Firmware ID: 50 33 58 46 0 47 4F 52

        <   4: Device initialized. Firmware ID: 50 33 58 46 0 47 4F 52

        2   SPI access - addr: 0x0, size: 0x800, pages: 0x8.

       

      Can you give me some advice?

       

      David